F1EB-13B414-AB Rear Bumper Light for FORD Focus 2015 Right

F1EB-13B414-AB Rear Bumper Light Overview

This product is listed for FORD Focus 2015 at the right rear-bumper position. This component completes the rear bumper lighting area and must match the correct side, lens type and vehicle trim.

Compare both the visible surface and the rear attachment geometry to avoid selecting a cosmetic look-alike.

At the right rear-bumper position, use the opposite-side component only as an alignment reference, not as an interchange part before deciding whether original hardware is suitable for reuse.

Model, Year and Side Confirmation

Use the product photograph to compare the exposed face and the concealed bracket layout as one assembly.

A correct vehicle name is only the starting point; market trim and facelift details can change the reflector opening.

When reviewing the 2015 vehicle, compare the outer lens edge with the moulded bumper recess because facelift bumpers can retain the same vehicle name with different apertures.

For the FORD Focus application, inspect the lower valance and nearby exhaust trim for adequate operating clearance so left- and right-hand stock cannot be mixed during consolidation.

Reflector Housing and Wiring Details

Confirm separately whether the removed component uses wiring, a bulb holder or an integrated LED module.

Inspect the moulded tabs from the rear and avoid placing package or hand pressure on the centre of the lens.

For this Focus body configuration, check the rear housing projection against the space behind the bumper skin so the approved product can be picked consistently in a mixed wholesale order.

Before approving the Focus part for packing, compare the bumper corner radius with the product face from more than one viewing angle so hidden brackets are not loaded or bent during installation.

Installation Preparation

Check the mounting direction and side before installation; left and right components are not automatically interchangeable.

Complete a visual alignment check from the rear and side, then test illumination when wiring is present.

Before fitting the right unit, align each locating tab with the matching slot before applying hand pressure to preserve access for a final electrical test where a lamp circuit is present.

While the FORD bumper opening is accessible, check whether the original component uses a separate retainer or an integral locking tab to reduce clip damage during a no-force trial installation.

Automotive Lighting Product Specifications

Wholesale Supply and Protective Packing

For repeat orders, quote the vehicle application and side together so the correct bumper variant is selected.

Before sealing the carton, compare the packed side and quantity with the buyer’s order line.

During comparison of the FORD rear component, verify the fastener direction and the shape of the concealed support frame to prevent a visually similar version from sitting proud of the bumper.

For a repeat order of the right version, protect the visible surface until the full perimeter gap has been accepted before the packaging and carton marking are finalized.

Frequently Asked Questions

Should original clips be reused?

Reuse hardware only when it is undamaged and correct for the photographed housing; replace distorted retainers.

What if the bumper opening differs?

Stop the installation and compare market version, trim level and hidden mounting geometry before modifying any part.

Which physical points matter most?

Compare exposed shape, housing depth, locating tabs, fastener spacing and any electrical connector.

What details help with a wholesale quote?

Provide vehicle, year, side, quantity, destination and clear photographs of the removed component.

Is this component illuminated or reflector-only?

Use the product photographs to confirm whether the rear body carries a connector, bulb holder or LED wiring.

Request a Product-Specific Quote

The quotation can include export packing requirements once the required variant and order volume are known.