92406-2T500 Rear Bumper Light for KIA K5 2014 Right

92406-2T500 Rear Bumper Light Overview

This product is listed for KIA K5 2014 at the right rear-bumper position. Function and fit are linked: the correct optical face must also align with the bumper surface and surrounding trim.

Production date and regional bumper specification should be reviewed when several near-identical versions are available.

For this K5 body configuration, review the reflector texture and lens colour in neutral workshop light because facelift bumpers can retain the same vehicle name with different apertures.

Physical Fitment Evidence

Check the bumper recess, outer contour and clip orientation; similar reflectors can use different hidden mounts.

Check whether the bumper carries a plain reflector or an illuminated unit before approving the replacement.

Before approving the K5 part for packing, record the approved side and vehicle application for repeat-order identification so left- and right-hand stock cannot be mixed during consolidation.

Before fitting the right unit, confirm that the cable exit, where fitted, clears the bumper reinforcement so the approved product can be picked consistently in a mixed wholesale order.

Surface, Seal and Electrical Interface

Do not add wiring to a reflector-only application; use the photographs to distinguish illuminated and passive versions.

Inspect the moulded tabs from the rear and avoid placing package or hand pressure on the centre of the lens.

While the KIA bumper opening is accessible, confirm that any connector seal remains square when the housing is fully seated so hidden brackets are not loaded or bent during installation.

During comparison of the KIA rear component, use the opposite-side component only as an alignment reference, not as an interchange part to preserve access for a final electrical test where a lamp circuit is present.

Bumper Assembly Check

After fitting, inspect flushness from several angles and test the lamp where an electrical function is present.

Make sure the component does not touch hot exhaust trim or trap wiring against a sharp body edge.

For a repeat order of the right version, compare the outer lens edge with the moulded bumper recess to reduce clip damage during a no-force trial installation.

On the 2014 K5 bumper layout, inspect the lower valance and nearby exhaust trim for adequate operating clearance to prevent a visually similar version from sitting proud of the bumper.

Automotive Lighting Product Specifications

Wholesale Supply and Protective Packing

Mixed orders should list left and right quantities separately and identify reflector-only and illuminated versions.

Before sealing the carton, compare the packed side and quantity with the buyer’s order line.

At the workshop selection stage for K5, check the rear housing projection against the space behind the bumper skin before the packaging and carton marking are finalized.

At the right rear-bumper position, compare the bumper corner radius with the product face from more than one viewing angle before inner liners make the rear attachment points difficult to inspect.

Frequently Asked Questions

Is this component illuminated or reflector-only?

Use the product photographs to confirm whether the rear body carries a connector, bulb holder or LED wiring.

What details help with a wholesale quote?

Provide vehicle, year, side, quantity, destination and clear photographs of the removed component.

Which physical points matter most?

Compare exposed shape, housing depth, locating tabs, fastener spacing and any electrical connector.

What if the bumper opening differs?

Stop the installation and compare market version, trim level and hidden mounting geometry before modifying any part.

Should original clips be reused?

Reuse hardware only when it is undamaged and correct for the photographed housing; replace distorted retainers.

Request a Product-Specific Quote

Provide the expected order quantity to receive a trade-oriented packing and supply proposal.