92405-A5100 Rear Bumper Light for HYUNDAI i30 2012 Left

92405-A5100 Rear Bumper Light Overview

This product is listed for HYUNDAI i30 2012 at the left rear-bumper position. This component completes the rear bumper lighting area and must match the correct side, lens type and vehicle trim.

Bumper designs can change during a model cycle, so verify the lens face and hidden support points together.

At the workshop selection stage for i30, verify the fastener direction and the shape of the concealed support frame so the visible gap remains even after every retaining point is engaged.

Application and Rear-Bumper Position

Use the product photograph to compare the exposed face and the concealed bracket layout as one assembly.

Production date and regional bumper specification should be reviewed when several near-identical versions are available.

At the left rear-bumper position, protect the visible surface until the full perimeter gap has been accepted so the lens and housing are supported without distortion.

When reviewing the 2012 vehicle, review the reflector texture and lens colour in neutral workshop light so a passive reflector is not confused with an illuminated assembly.

Optical Face and Connector Review

Confirm separately whether the removed component uses wiring, a bulb holder or an integrated LED module.

Check the lens for scratches, cracks and distortion, then compare its moulded edge with the original component.

For the HYUNDAI i30 application, record the approved side and vehicle application for repeat-order identification to verify that the photographed configuration matches the vehicle in the workshop.

For this i30 body configuration, confirm that the cable exit, where fitted, clears the bumper reinforcement to avoid contact with wiring, body edges or hot exhaust components.

Workshop Fitting Sequence

Check the mounting direction and side before installation; left and right components are not automatically interchangeable.

Verify that bumper movement does not load the lens and that the component remains fully clipped at every corner.

Before approving the i30 part for packing, confirm that any connector seal remains square when the housing is fully seated to keep the optical face level with the surrounding painted surface.

Before fitting the left unit, use the opposite-side component only as an alignment reference, not as an interchange part before any modification is made to the bumper or replacement part.

Automotive Lighting Product Specifications

Wholesale Supply and Protective Packing

For repeat orders, quote the vehicle application and side together so the correct bumper variant is selected.

Before sealing the carton, compare the packed side and quantity with the buyer’s order line.

While the HYUNDAI bumper opening is accessible, compare the outer lens edge with the moulded bumper recess before deciding whether original hardware is suitable for reuse.

During comparison of the HYUNDAI rear component, inspect the lower valance and nearby exhaust trim for adequate operating clearance because facelift bumpers can retain the same vehicle name with different apertures.

Frequently Asked Questions

Can appearance alone confirm compatibility?

No. A similar colour and outline can hide different clips, housing depth, wiring or side orientation.

Why can the same model year use another version?

Regional equipment, facelift changes and bumper trim packages can alter the opening or electrical configuration.

How should the visible lens be packed?

Keep it isolated from carton pressure, loose hardware and neighbouring products with separate support for tabs.

Can the opposite side use the same part?

Do not assume interchangeability; lens angle, contour, clips and bumper recess are normally side-specific.

How is a passive reflector checked?

Confirm the lens orientation, reflective face and flush fit without adding wiring that was not present originally.

Request a Product-Specific Quote

Repeat buyers can reference the vehicle application and side from their previous approved sample.