92401-4Z500 Tail Light for HYUNDAI Santa Fe 2016 Left
Primary OE reference: 92401-4Z500
Product type: Tail Light
Applicable vehicle: HYUNDAI Santa Fe 2016
Installation position: Rear body / tail lamp opening
Side / orientation: Left
Brand: HYUNDAI
Model: Santa Fe
Vehicle year: 2016
Housing check: Compare the lens contour, inner edge, locating tabs and rear casing depth with the original lamp. Similar-looking versions may use different brackets or body openings.
Electrical interface: Match the electrical socket and locking tab before installation. Confirm separately whether the original vehicle uses replaceable bulbs, an LED board or an external control unit.
Installation guidance: Support the assembly during fitting and engage each guide pin squarely. After fastening, verify panel alignment, sealing contact and all lighting functions.
Wholesale enquiry: Trade orders can be prepared by side and vehicle application. Sharing clear images of the removed lamp helps confirm connector and mounting differences before packing.
92401-4Z500 Tail Light Overview
Designed as a vehicle-specific rear lighting replacement, this lamp should be selected by comparing the original housing, lens outline and mounting layout.
The listed application is HYUNDAI Santa Fe 2016, with the lamp positioned on the left side. Use the photographs and specification table together when comparing the removed assembly.
Vehicle Fitment and Lamp Selection
Use the product photographs to confirm the lamp outline, corner radius, mounting ears and the relationship between the lens and surrounding body trim.
Confirm the production period and lighting package as well as the vehicle model. Facelift changes, regional equipment and body variants can alter the lens, reflector or fixing arrangement.
Housing, Lens and Electrical Interface
The connector interface must seat fully without bending terminals or modifying the harness. Verify any bulb carrier, resistor or electronic module shown on the original assembly.
Inspect the lens for transport damage before fitting. The rear casing, vents and sealing edges should remain clean so moisture control and body fit are not compromised.
Installation Guidance
Remove debris from the body opening and inspect the seal before installation. Tighten the fixings evenly, then confirm that the lamp does not contact adjacent panels.
After installation, test the parking light, brake light, turn signal, reversing light and fog-light function where applicable. Verify that no warning message remains on the instrument panel.
Automotive Lighting Product Specifications
| Product type | Tail Light |
|---|---|
| Primary OE reference | 92401-4Z500 |
| Cross-reference numbers | 92401-4Z500 |
| Internal item code | HY04003-165 |
| Vehicle brand | HYUNDAI |
| Vehicle model | Santa Fe |
| Model year | 2016 |
| Installation position | Rear body / tail lamp opening |
| Side / orientation | Left |
| Selection basis | OE reference, vehicle application and physical comparison |
Wholesale Supply and Packing
When requesting a quotation, include quantity, destination and the exact rear position. Mixed orders should list left and right lamps on separate lines.
The lens face, connector area and projecting brackets should be isolated inside the carton. Separate labels for left- and right-hand units help prevent picking errors in mixed shipments.
Frequently Asked Questions
Are bulbs or electronic modules included?
The supply scope follows the product photographs. Ask separately about bulbs, holders, LED drivers, wiring and control modules if they are not clearly shown.
Can a similar-looking lamp be used instead?
Appearance alone is not sufficient. The body opening, housing depth, mounting points, connector and lighting technology must all match.
What should be checked before installation?
Compare the removed lamp with the supplied images, inspect the seal and brackets, confirm the electrical plug and carry out a dry fit before final tightening.
What details are required for a trade quotation?
Provide the vehicle application, production year, installation side, quantity, destination and clear photographs of the original lamp.
Request a Product-Specific Quote
Contact Yongshang Auto with the vehicle details, required side, quantity and destination. The photographed configuration can be reviewed before a wholesale quotation is prepared.
