92406-B4700 Rear Bumper Light for HYUNDAI i10 2017 Right

92406-B4700 Rear Bumper Light Overview

This product is listed for HYUNDAI i10 2017 at the right rear-bumper position. Function and fit are linked: the correct optical face must also align with the bumper surface and surrounding trim.

Use the removed component as the physical reference for outer shape, housing projection and clip location.

During comparison of the HYUNDAI rear component, compare the bumper corner radius with the product face from more than one viewing angle to preserve access for a final electrical test where a lamp circuit is present.

Rear-Bumper Geometry Review

Check the bumper recess, outer contour and clip orientation; similar reflectors can use different hidden mounts.

Bumper designs can change during a model cycle, so verify the lens face and hidden support points together.

For a repeat order of the right version, align each locating tab with the matching slot before applying hand pressure to reduce clip damage during a no-force trial installation.

On the 2017 i10 bumper layout, check whether the original component uses a separate retainer or an integral locking tab to prevent a visually similar version from sitting proud of the bumper.

Lens, Housing and Harness Comparison

Do not add wiring to a reflector-only application; use the photographs to distinguish illuminated and passive versions.

Inspect the moulded tabs from the rear and avoid placing package or hand pressure on the centre of the lens.

At the workshop selection stage for i10, verify the fastener direction and the shape of the concealed support frame before the packaging and carton marking are finalized.

At the right rear-bumper position, protect the visible surface until the full perimeter gap has been accepted before inner liners make the rear attachment points difficult to inspect.

Installation Completion

After fitting, inspect flushness from several angles and test the lamp where an electrical function is present.

After installation, confirm the lens is level with nearby trim and that no retaining tab has backed out.

When reviewing the 2017 vehicle, review the reflector texture and lens colour in neutral workshop light so the visible gap remains even after every retaining point is engaged.

For the HYUNDAI i10 application, record the approved side and vehicle application for repeat-order identification so the lens and housing are supported without distortion.

Automotive Lighting Product Specifications

Wholesale Supply and Protective Packing

Mixed orders should list left and right quantities separately and identify reflector-only and illuminated versions.

The visible face should remain separated from tape, staples and loose hardware throughout transport.

For this i10 body configuration, confirm that the cable exit, where fitted, clears the bumper reinforcement so a passive reflector is not confused with an illuminated assembly.

Before approving the i10 part for packing, confirm that any connector seal remains square when the housing is fully seated to verify that the photographed configuration matches the vehicle in the workshop.

Frequently Asked Questions

Is this component illuminated or reflector-only?

Use the product photographs to confirm whether the rear body carries a connector, bulb holder or LED wiring.

What details help with a wholesale quote?

Provide vehicle, year, side, quantity, destination and clear photographs of the removed component.

Which physical points matter most?

Compare exposed shape, housing depth, locating tabs, fastener spacing and any electrical connector.

What if the bumper opening differs?

Stop the installation and compare market version, trim level and hidden mounting geometry before modifying any part.

Should original clips be reused?

Reuse hardware only when it is undamaged and correct for the photographed housing; replace distorted retainers.

Request a Product-Specific Quote

A product-specific quotation can be prepared after the vehicle, side and destination are confirmed.